Bagging The Clippings; Operating The Bag-On-Demand Lever - Toro 48cm 60V Super Recycler Bedienungsanleitung

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the bag-on-demand lever is in the recycling position, move it to the bagging position; refer to
Bag-on-Demand Lever (page
Installing the Grass Bag
1. Raise and hold up the rear deflector (A of
2. Install the grass bag, ensuring that the pins on the bag rest in the notches on the handle (B of
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
Operating the
Bag-on-Demand Lever
The bag-on-demand feature allows you to either
collect or recycle grass and leaf clippings while the
grass bag is attached to the machine.
•
To bag the grass and leaf clippings, press the
button on the bag-on-demand lever and move the
lever forward until the button on the lever pops up
(Figure 15).
Figure 15
1. Bag-on-demand lever (in
the recycling position)
•
To recycle or side-discharge the grass and
leaf clippings, press the button on the lever and
15).
Figure
Installing the Grass Bag (page
g251583
2. Bag-on-demand lever (in
the bagging position)
14).
Figure 14
15).
move the lever rearward until the button on the
lever pops up.
Important:
any grass clippings and debris from the
bag-on-demand door and the surrounding
opening (Figure
bag-on-demand lever from 1 position to
another.
1. Clean here
15
Operating the
For proper operation, remove
16) before you move the
Figure 16
Figure 14).
g233434
g251584