Unfolding The Handle - Toro 48cm 60V Super Recycler Bedienungsanleitung

2

Unfolding the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
Important:
Remove and discard the protective
plastic sheet that covers the motor and any other
plastic or wrapping on the machine.
1. Loosen the handle knobs
1. Handle knobs
2. Carefully move the upper handle forward until
the handle halves are in line and nest together
as shown in Figure
(Figure 4).
Figure 4
5.
Figure 5
3. Tighten the handle knobs firmly by hand.
4. Rotate the handle rearward to the operating
position, and lock the handle at your desired
height. Refer to
(page 13).
g335758
g335780
9
Adjusting the Handle Height