Add Current; Battery; Display Separately; Display Priority - SIMARINE Caravan Benutzerhandbuch

6.9.3.4.4

Add current

There can be multiple current sensors (shunts) connected to a single battery. With this setting, you can define which currents
must be added together to get the total current on a certain battery. Set this value to ON for all the shunts which should be
added together to calculate the total current on the battery. Set this value to OFF for all the other shunts.
Example 1: One sensor may monitor the total current on the battery and the other sensors may be used to monitor certain
consumers or generators. Set this value to ON for the sensor which monitors the total current on the battery. Set this value
to OFF for all the other sensors.
Example 2: Three shunts may be connected to the battery in parallel to monitor the consumption in three different
branches. To summarize the total current on the battery, the currents of all three shunts must be added together. In this
case, set the value to ON for all three shunts.
6.9.3.4.5

Battery

Used to select the battery to which the sensor is connected.
6.9.3.4.6

Display separately

By default, this option is deactivated. If the option is activated, the current value is displayed on a separate screen dedicated
to current values. Up to 12 current values can be displayed on one screen simultaneously.
6.9.3.4.7

Display priority

This setting enables you to select one of the following display priorities: HIGH, MEDIUM, LOW, and HIDE.
Use the display priority for ordering current sensors on the screen of the Caravan Panel. When current sensors are shown on
the screen, those with HIGH display priority are shown first (at the top), followed by sensors with MEDIUM display priority.
Sensors with LOW display priority are shown last (at the bottom). If you select HIDE, this sensor will not appear on the
Batteries screen (it will be hidden).
6.9.3.4.8

Device

Displays device name, serial number, and port. Device name [serial number] port. Example: SC501[12345678]
6.9.3.4.9

Merge with

The function allows you to combine two or more current sensors and add up currents together. Simply select from the list to
which current sensor you want to connect the sensor.
Example: when using an SCQ25 module you can merge 2, 3, or all 4 shunts and consequently we have a 100A (4x25A) shunt.
It is possible to merge current sensors that are not on the same device.
50