6.9.3.3.1
Name
Here, you can view or edit the temperature sensor name.
6.9.3.3.2
Type
Here, you can view or change the temperature sensor type. Supported models: NTC 10K and NTC 5. These are 10kOhm and
5kOhm thermistors with a negative temperature coefficient.
6.9.3.3.3
Device
The device and input to which the sensor is connected. For example: if the sensor is connected to the ST107 module and its
input R1, select the option ST107 [serial number] R1.
6.9.3.3.4
Display priority
This setting enables you to select one of the following display priorities: HIGH, MEDIUM, LOW, and HIDE.
Use the display priority for ordering the thermometers on the screen of the Caravan Panel. When thermometers are shown
on the screen, those with HIGH display priority are shown first (leftmost), followed by thermometers with MEDIUM display
priority. Thermometers with LOW display priority are shown last. If you select HIDE, the level of this thermometer will not
appear on the Temperatures screen (it will be hidden).
6.9.3.3.5
Range MIN
The Caravan Panel shows the thermometer with a graphical representation (vertical bar), together with the current
numerical value. This option defines minimum value (temperature) of the thermometer bar.
6.9.3.3.6
Range MAX
The Caravan Panel shows the thermometer with a graphical representation (vertical bar), together with the current
numerical value. This option defines maximum value (temperature) of the thermometer bar.
6.9.3.3.7
Calibration
This setting enables you to calibrate the sensor value. If the displayed value is too high, you can use a negative calibration
value (offset). If the displayed value is too low, you can use a positive calibration value (offset).
6.9.3.3.8
Delete
With this option, you can delete the selected temperature sensor.
48