Add New Battery - SIMARINE Caravan Benutzerhandbuch

6.6.1

Add new battery

The following steps are valid for digital shunts SC303, SC302T and SC503.
In the settings menu, navigate to DEVICES > BATTERIES.
Select "Add new" and fill in the required data.
Name the battery/battery bank accordingly (STARTER, SERVICE, MAIN, etc.)
·
Select the battery type (Wet low maintenance, Wet maintenance free, AGM, Deep cycle, Gel, LiFePO4).
·
Fill in the battery capacity for the next C ratings: C/20, C/10, and C/5. If you don't know all the ratings, fill in just the
·
ratings that you know. It is highly recommended to fill at least two C ratings (one is not enough for precise calculations). A
C rating is simply a battery's capacity (or Ah/amp hour rating) when discharged over a specific period. Usually, the C
rating is specified on the battery label. For correct operation, set unknown ratings as "Not set"!
Select a voltmeter connected to the battery. You can only see voltmeters that are not already used by other battery
·
configurations.
· Select the current sensor connected to the battery. You can only select current sensors that are not already used by an
existing battery configuration. For a battery configuration without a shunt, leave the current sensor empty.
Select a temperature sensor if you have one installed.
·
· Confirm and save the battery configuration with the
visible on one of the Caravan's screens.
button. After you exit the settings menu, the new battery should be
32