ALARM STATE is used to enable or disable the alarm.
·
ALARM VALUE is a limit value which activates the alarm.
·
SILENT, if enabled, there will be no audible signal when the alarm activates. The alarm warning will only appear on the
·
screen of the Caravan Panel.
ALARM DELAY is the time delay of the alarm activation. The alarm activates when the measured value is below (for alarm
·
low) or above (for alarm high) the alarm value during the delay period.
ALARM DURATION is the selected duration of the alarm. It is set to 5 minutes by default.
·
OUTPUT is the digital output that is turned on during an active alarm.
·
6.9.2.1
Alarm screen
When an alarm is triggered, it is shown on the Caravan Panel (see image below). There you can change the alarm state:
·
Hide hides the alarm from the display, but it is still active in the background. The output is active (if it is set up).
Snooze for 5 or 30 minutes, which means it is hidden for 5 or 30 minutes and then displayed again if still active. The output
·
is active (if it is set up).
·
Dismiss turns the alarm and output (if it is set up) off for 24h.
If multiple alarms are active at the same time, they are displayed alternately.
39