Auto Sleep; Sleep After; Sleep Screen; Battery - SIMARINE Caravan Benutzerhandbuch

6.9.1.2.1

Auto sleep

If enabled, the Caravan Panel goes into sleep mode after SLEEP AFTER time.
6.9.1.2.2

Sleep after

Time after which the Caravan Panel goes into sleep mode if the AUTO SLEEP setting is enabled.
6.9.1.2.3

Sleep screen

If SLEEP SCREEN is enabled, Caravan Panel will show sleep screen if it is in sleep mode.
6.9.1.2.4

Battery

Here you can select between available batteries.
6.9.1.2.5

Left button

Here you can configure the left button of the Caravan Panel.
You can configure the left button to have the function SLEEP or POWER OFF.
By holding the left button, the function will execute.
6.9.1.2.6

Power management

Here, you can enable and set the time of the automatic power off of the Caravan Panel.
6.9.1.3

Language

You can select between English, German, and French. More languages will be added with future firmware upgrades.
6.9.1.4

Units

You can choose different international units for pressure, temperature, volume, altitude, and speed.
6.9.2

Data management

This menu enables you to set up alarms for specific measurements. Here you can choose the quantity, the device, low and
high values for alarm, and you can turn the high/low-value alarms on and off.
· ALARM LOW: Low-value alarm activates when the measured value is lower than the set alarm value.
ALARM HIGH: High-value alarm activates when the measured value is higher than the set alarm value.
·
After you select ALARM LOW or ALARM HIGH, the following alarm settings will appear:
38