Operating Mower; Using 3 Point Hitch Attachment Or Front Loader; Removing The Mower Deck - Kubota RCK60B-23BX Bedienungsanleitung

18 OPERATION

OPERATING MOWER

To avoid serious injury or death:
A Do not operate the mower without the
discharge deflector properly.
To avoid personal injury:
A When operating the mower on a hillside, be
sure to remove the loader to avoid the risk of
roll over.
To avoid personal injury:
A Remove foreign objects, such as rocks, cans,
bottles, etc., from the area to be mowed.
A Do not direct the opening of the deflector
towards bystanders or animals. Thrown object
may cause injury. Plan your mowing pattern
carefully before starting operations.
A Keep bystanders and animals away from the
mowing area.
A When not using the mower, shift the PTO
clutch control lever to the "OFF" position.
A When operating the loader in rough terrain, remove
the mower to avoid damage to the mower.
1. Keep the engine running at full throttle for best results.
Control ground speed by using the control pedal of the
tractor.
2. During heavy duty use, operate the tractor at a slower
ground speed or go over the area twice.
3. Keep the mower deck in the fully raised position when
the mower is not being used.
4. The mower will not cut cleanly if the ground speed is
too high or if the blade speed drops due to an
overload, or if the blades are dull.
A To prevent the engine from overheating, keep the
radiator and radiator net clean.
USING 3 POINT HITCH ATTACHMENT OR
FRONT LOADER
To avoid personal injury:
A When not using the mower, shift the PTO
clutch control lever
position.
To use a 3 point hitch mounted attachment or the front
loader when the mower is attached, follow the procedure
below.
1. Turn on the engine.
2. Move the hydraulic control lever rearward to raise the
mower to the highest position.
3. Turn the cutting height control dial to "TOP" position,
and lower the mower.
4. Stop the engine and remove the key.
5. Set the gauge wheels to the lowest hole to get the
maximum ground clearance.
A Do not change the length of the mower lift links.

REMOVING THE MOWER DECK

To avoid personal injury:
A Park the tractor on a firm, flat and level surface,
set the parking brake.
A Stop the engine and remove the key.
1. Park the tractor on a firm, flat and level surface and set
the parking brake.
2. Move the hydraulic lever rearward to raise the mower
rear links to the highest position.
3. Set the cutting height control dial to "TOP" position.
4. Stop the engine and remove the key.
5. Turn the anti-scalp roller sideways.
[RCK60B-23BX, RCK54-23BX]
6. Restart the engine, move the hydraulic lever rearward
to raise the mower rear links to the highest position,
set the cutting height control dial to zero position and
move the hydraulic lever forward to lower the mower
rear links.
7. Remove the rear links from the mower.
8. Move the hydraulic lever rearward to raise the mower
rear links.
9. Stop the engine and remove the key.
10. Pull back the coupler of the universal joint to unlock the
coupler.
11. Remove the front link, then remove the mower deck.
to the "NEUTRAL"