Adjusting The Self-Balance Suspended Linkage - Kubota Rck60B-23Bx Bedienungsanleitung

6. Turn the cutting height control dial to the desired
height. Set the anti-scalp rollers' height to keep
clearance between rollers and ground from 6 to 13 mm
as shown in "OPERATION" section.
(1) Cutting height control dial
(2) Hydraulic control lever
7. Lower the mower deck by moving the hydraulic control
lever forward.
8. Turn left blade by hand parallel to tractor axle and turn
right blade parallel to axle to measure from the outside
blade tip at (L) and (R) to the level surface. The
difference between measurements should be less
than 3 mm.
MOWER ADJUSTMENTS
9. If the difference between measurements is more than
3 mm, loosen the lock nut of the left side. Adjust the
cutting height fine tuning bolts so that the difference
between measurements (L) and (R) is less than 3 mm.
Then lock the nut.
(1) Cutting height fine tuning bolt
(2) Lock nut
ADJUSTING THE SELF-BALANCE
SUSPENDED LINKAGE
[RCK60B-23BX only]
A This system reduces the stepped differences in cutting
height when mowing rolling terrain.
Adjust the height of springs so that (H) is 55 mm.
(1) Self-balancer
(2) Balancer spring
(3) Lock nut
(4) Plain washer
(5) Mower deck
15
(H) 55 mm