Herunterladen Diese Seite drucken

Cleaning, Care And Maintenance; Replacing Fuses; Service; Disposal - Formula 1 Power Jumpstarter PJ125 Originalbetriebsanleitung

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
EN
Problem
The device is pumping air but
the tyre/item is not inflating.
The pressure in the tyre is less
than the set pressure.
The battery pack will not be
charged.
Cleaning,
c are and
maintenance
Always disconnect the air and power station
from the 230 V power supply and disconnect
external devices before cleaning or performing
maintenance.
To prevent corrosion, wipe off any battery fluid
which may have come into contact with the
clamps.
Keep the air inlets and outlets free from dirt
and dust. Clean the device with a damp cloth.
Do not use abrasive utensils for cleaning.
Store the device in a protected, dry location.
Do not store the device in areas where it is
exposed to extreme temperature fluctuations!
Condensation will form, which can damage the
electronics!

Replacing fuses

1. Using a pair of flat-nose pliers carefully pull
the flat fuse inside the housing unit for the
controls.
2. Replace the defective fuse with a new 30 A
flat fuse by carefully pushing the new fuse
into the fuse holder with your thumb until it is
flush with the unit housing
24
f1.mts-gruppe.com
Possible cause
Valve adapters not connected
properly.
Tyre/item leaking.
Tyre too hot.
Tyre volume too great.
The fuse has blown.

Service

Should you have any questions regarding com-
missioning or operating in spite of studying these
operating instructions, or if a problem should oc-
cur against all expectations, please get in contact
with your specialist supplier.

Disposal

The packaging consists of non-contaminating
materials that you can dispose of at your local
recycling point.
In accordance with European Directive 2012/19/
EC for waste electrical and electronic equipment
(WEEE) and conversion to national law, used
electrical appliances must be collected separately
and taken to a recycling point. For ways to dispo-
se of old electrical appliances please contact your
community or city administration.
Rechargeable batteries and batteries must be re-
moved before disposal of the device and disposed
of separately from the device. Do not dispose of
waste devices with household rubbish. Discharge
used battery packs and return the battery packs
to a public waste management or collection site.
Properly dispose of damaged or defective battery
packs in compliance with local regulations.
Illustrations may vary slightly from the product
itself. We reserve the right to modify the product
in accordance with technical advances. Decorati-
on not included.
Solution
Ensure the chuck (23) is properly connected to
the valve of the tyre/item.
Check if the tyre/product is leaking air.
The tyre pressure increases as the tempera-
ture rises. The recommended tyre pressure is
typically specified for cold tyres (approx. 20 °C).
Do not check the tyre pressure on warm tyres
(e.g. after long trips). Please refer to the owner's
manual for your vehicle.
With large tyres such as on campers it's advisa-
ble to increase the pressure by 2 PSI (0.1 bar) to
compensate for the high volume.
Replace the fuse (see chapter „Replacing
fuses").
Do not throw electrical appliances in with
domestic waste!

Werbung

Fehlerbehebung

loading