Troubleshooting - Formula 1 Power Jumpstarter PJ125 Originalbetriebsanleitung

3. After using the external device, disconnect the
12 V car plug from the 12 V car socket.
4. Press the „12V" button (1) again to switch off
the 12 V car socket (12).
Using the 2.0 USB output socket
1. Press the button (2) to switch on the USB
port (8).
2. Plug an external USB device into the USB
port (8).
Trouble shooting
Problem
Device isn't working.
Low voltage alarm is always
on.
Low output voltage.
TV operation and / or Audio
systems and / or external
appliances
Snow image
image not steady
Humming, booming and whir-
ring sound audible
The On/Off switch (15) is on
but the compressor does not
start inflating.
The device does not auto-
matically stop inflating at the
preset.
The USB port delivers 5 V of direct current for
external USB devices (e.g. lamps, fans, radios).
Note:
•
The USB port is not intended for data transfer.
•
Do not connect memory sticks, MP3 player or
similar data storage external appliances.
3. Press the
Possible cause
Battery pack defective or
drained.
The power draw of the con-
nected device is too high.
Device operation was inter-
rupted by one of the safety
systems.
The fuse has blown.
Voltage or power are not suf-
ficient to power the inverter.
Input voltage too low - Low
voltage-protection.
Polarity, incorrect connections,
short-circuit protection.
Rated power above max.
Rated power - overload
protection.
TV interference.
Battery pack drained.
Pressure setting incorrect.
button (2) again to switch off the
USB port (8).
Solution
Replace or charge the battery pack.
Disconnect the external device.
The maximum power draw should not exceed
the power rating of the voltage converter.
See the relevant chapter ( Technical Features).
Replace the fuse (see chapter „Replacing
fuses").
Check connections and verify whether is a pro-
blem caused by cables (not clean or damaged)
or the clips.
Immediately switch off the voltage converter.
Check the connections and charge the battery
pack.
Switch off the power inverter immediately.
Disconnect all external appliances. Check all
connections, cables and external appliances.
Adjust where necessary.
Reduce the total power of connected devices to
the max. power rating.
Place power inverter as far away from TV set
as possible.
Check aerial connection and setting. Place aerial
cable away from power inverter. Use a shielded
aerial cable.
Verify the battery pack is charged
Verify the correct values were preset.
Power Jumpstarter PJ125
EN
23