Hach PAH500 Bedienungsanleitung Seite 29

Event
DEV DRV UPDATE
FLASH FAIL
OUT MODE
SENSOR MISSING
SENSOR OK
CLEAN SENSOR
RESET SENSOR
1 POINT MANUAL
2 POINT MANUAL
CAL COMPLETE
CAL FAIL
CAL ABORT
RESET CONFIGURE
RESET CALIBRATE
CONC TOO HIGH
Section 7 Replacement parts and accessories
Replacement parts
Description
Mounting Hardware Kit, includes:
Mounting brackets and hardware for one sensor and digital
gateway
Cleaning swabs
Accessories
Description
Digital extension cable, 1 m (3.2 ft)
Digital extension cable, 7.7 m (25 ft)
Digital extension cable, 15 m (50 ft)
Digital extension cable, 31 m (100 ft)
Calibration Kit, includes:
50 ppb and 25 ppb phenanthrene ampules, deionized
water, cleaning swabs, drain valve, plug, ampule breaker,
vials and disposable pipettes
Table 4 Event list (continued)
Description
A device driver update was done.
A flash memory failure occurred.
The data log inhibit/output mode was changed.
The sensor is missing or disconnected.
The sensor is connected again.
The sensor was cleaned.
The sensor was reset.
A 1-point calibration was started.
A 2-point calibration was started.
A 2-point calibration was fully completed.
A 2-point calibration failed.
A 2-point calibration was stopped.
The user setting were set to the factory defaults.
The calibration slope and offset were set to the factory
defaults.
The measured PAH is higher than the measurement range of
the sensor.
Quantity Item no.
1 LXZ541.99.0001H
50 9770700
Quantity Item no.
1 6122400
1 5796000
1 5796100
1 5796200
1 LZC541
English 29