Klarstein Aromatica Taste 10 Bedienungsanleitung Seite 17

EN
5. Brewing settings
In standby mode, press the button to select the only brewing function. Press until
the brewing symbol appears in the display. To brew, press the ON/OFF switch. The
machine starts the brewing without grinding operation. The operating indicator flashes.
6. Grinding and brewing
When the , or symbol is lit on the display, the machine is in grinding and
brewing mode. You can set the coffee strength with the button. Press the button
to set the number of cups.
Press the ON/OFF button to start the process. The machine first grinds the beans and
then brews the powder. When the water has completely drained from the tank, the
machine switches to keep warm mode.
7. Keep warm mode
When the brewing process is complete, the appliance goes into keep warm mode. The
operating light is on and the appliance indicates this by humming three times. When the
warm-keeping mode ends (after 40minutes max.), the machine goes into standby mode.
The unit hums three times and the operating lamp goes out.
8. Decalcification mode
When the machine needs to be cleared of calcium, the clear calcium icon on the
display will illuminate.
Decalcify the machine with a commercially available decalcifier or a water/vinegar
mixture. Fill the water tank with the mixture and run the mixture through the machine
once. Then fill the water tank with fresh, clean water up to the MAX mark and allow the
water to run through as well.
In standby mode, briefly press the CALC button to start the decalcification process. The
light on the CALC button flashes and the display shows the symbol .Press the CALC
button to stop the decalcification process after a few minutes (or during the process).
Decalcification is complete.
Abnormal indication: Buzzer beeps twice and machine will enter the standby mode
when the gate above the filter holder is closed or opened abnormally.
17