Instruction Manual; Intended Use; Power Supply - Makita LC1230 Bedienungsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Blade diameter
Hole (arbor) diameter
Max. kerf thickness of the saw blade
No load speed
Dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Cutting capacity
Workpiece shape
Cutting angle
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
Do not place hand or fingers close to the
blade.
To avoid injury from flying debris, keep hold-
ing the saw head down, after making cuts,
until the blade has come to a complete stop.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Only for EU countries
Do not dispose of electric equipment together
with household waste material! In observance of
the European Directive, on Waste Electric and
Electronic Equipment and its implementation
in accordance with national law, electric equip-
ment that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility.
Model
Net weight
Safety class
90°
45°
516 mm x 306 mm x 603 mm
115mm
90mm

Intended use

The tool is intended for cutting in mild steel and stain-
less steel with appropriate saw blades.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.25 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protec-
tive circuit breaker having slow tripping characteristics.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-3-10:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
5 ENGLISH
LC1230
305 mm
25.4 mm
2.5 mm
-1
1,700 min
19.2 kg
/II
A X B B
A
A
75 mm x 150 mm
100 mm x 100 mm
85 mm x 85mm
) : 107 dB(A)
pA
) : 115 dB (A)
WA