Checking The Tire Pressure; Checking The Wheel Lug Nuts - Toro Z Master 4000 Serie Bedienungsanleitung

Figure 55
Right control lever shown
1. Tracking screw
g334735
2. Access hole on the front
cover panel

Checking the Tire Pressure

For Machines with Pneumatic
Tires Only
Service Interval: Every 50 hours/Monthly (whichever
comes first) For machines with
pneumatic tires only.
Maintain the air pressure in the rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut.
Check the tires when they are cold to get the most
accurate pressure reading.
Checking the Wheel Lug
Nuts
Check and torque the wheel lug nuts to 122 to 136
N∙m (90 to 100 ft-lb).
47
Figure 56
g001055