Installing The Battery - Toro Z Master 4000 Serie Bedienungsanleitung

4. Install the battery in the machine and connect
the battery cables; refer to
(page 45).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 52
1. Positive (+) battery post
2. Negative (–) battery post

Installing the Battery

g000960
3. Red (+) charger lead
4. Black (–) charger lead
Installing the Battery
1. Position the battery in the tray with the terminal
posts opposite from the hydraulic tank
51).
2. Install the positive (red) battery cable to the
positive (+) battery terminal.
3. Install the negative (black) battery cable and
ground wire to the negative (-) battery terminal.
Note:
For MyRide machines, ensure that the
ground cable does not rub against the trailing
arm or lower shock mount
1. Ensure that the ground
cable does not rub against
the lower shock mount.
2. Ensure that the ground
cable does not rub against
the trailing arm.
4. Secure the cables with 2 bolts, 2 washers, and
2 locknuts (Figure
5. Slide the red terminal boot onto the positive (+)
battery terminal.
6. Secure the battery with the rubber strap
51).
45
(Figure
(Figure 54).
Figure 53
3. Ground cable
51).
g334253
(Figure