Cleaning The Cooling System; Cleaning The Engine Screen - Toro 2000 HDX RD Serie Bedienungsanleitung

2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the area around the base of the plug to
keep dirt and debris out of the engine.
4. Locate and remove the spark plug(s) as shown
in Figure 46.
Figure 46
Checking the Spark Plug(s)
Important:
Do not clean the spark plug(s).
Always replace the spark plug(s) when it has a
black coating, worn electrodes, an oily film, or
cracks.
If you see light brown or gray on the insulator, the
engine is operating properly. A black coating on the
insulator usually means the air cleaner is dirty.
Set the gap to 0.75 mm (0.03 inch).
Figure 47
Installing the Spark Plug(s)
g036857
Cleaning the Cooling
g027478
System
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the air filter from the engine.
4. Remove the engine shroud.
5. To prevent debris entering the air intake, install
the air filter to the filter base.
6. Clean debris and grass from the parts.
7. Remove the air filter and install the engine
shroud.
8. Install the air filter.

Cleaning the Engine Screen

Service Interval: Before each use or daily
g206628
Before each use or daily
Before each use remove any buildup of grass, dirt, or
other debris from the engine screen, engine exhaust,
and the area around the engine. This helps ensure
adequate cooling and correct engine speed and
reduces the possibility of overheating and mechanical
damage to the engine.
39
Figure 48
g027960