Petsafe Stay & Play Gebrauchsanleitung Seite 11

Two-Person Method
Hold the receiver collar around waist height with logo side facing away from the transmitter and contact points facing upwards. Walk to the
edge of the desired pet area. Facing away from the transmitter, hold the receiver collar at the edge of the desired pet area (4C).
Starting with the boundary control dial set to "8", have a second person turn the dial down SLOWLY. When the receiver collar tone starts, tell
the person to stop turning the boundary control dial. Walk back into the pet area until the receiver stops sounding. Verify the pet area boundary
by walking towards the boundary zone and verifying that the tone/test light flashes begin at the desired location. Test at multiple locations
around the pet area to verify that the pet area is within your desired location. Record your settings below for future reference.
One-Person Method
Measure the shortest distance from the desired boundary zone to the transmitter. See the transmitter range chart below and set the boundary
switch and boundary control dial. Hold the test light contacts to the contact points (4B). Take the receiver collar to the boundary zone with
the logo side facing away from the transmitter and contact points facing upwards (4C). Hold the receiver collar around waist height until the
receiver collar tone sounds and the test light flashes. If the receiver collar tone sounds before or after the desired boundary zone, return to the
transmitter and adjust the boundary control dial. Repeat this process until the receiver collar tone sounds at the desired location. Record your
settings below for future reference.
4A
Transmitter Range Chart
Boundary Control Dial Position
1
2
3
4
5
6
7
8
Note: These distances are approximate.
Record Your Settings
Location
Setting (HIGH + or LOW – )
Home
Camping
Holidays
Other
4B
Pet Area
Street
Boundary Switch LOW –
Final Boundary Switch
4C
1.5 m
3 m
4.5 m
6 m
7.5 m
9 m
12 m
15 m
Final Boundary Control Dial
Position (1–8)
petsafe.com
Pet
Area
Boundary Switch HIGH +
1.5 m
6 m
10.5 m
15 m
20 m
24 m
29 m
32 m
Receiver Static Stimulation
Level (1–6)
11