Security Settings; Sip Settings - Auerswald COMfortel WS-400 IP Inbetriebnahmeanleitung

Commissioning
Select one of the following options from the Method list field
2.
displayed under IPv4:
Use Static IP Address: The IP DECT server is assigned
a fixed IP address (recommended).
DHCP assigned: The IP DECT server gets its IP address
automatically from a DHCP server.
Only for Use Static IP address:
3.
Enter the IP DECT server's IP address in the IP addr
entry field.
Enter the network mask in the Netmask entry field.
Enter the gateway name in the Gateway entry field.
Under NTP, enter the NTP server's IP address in the Server
4.
entry field.
Select the time zone from the Time zone list field.
5.
Click Save > OK > Reboot now > OK.
6.

Security Settings

Open the Configuration > Security page.
1.
Enter the current password in the Current Password entry
2.
field.
Enter a new user name in the New username entry field.
3.
Enter a new password in the New password entry field.
4.
Then enter the new password again in the New password
5.
again entry field.
Click Save > OK.
6.

SIP Settings

– Knowledge of the DECT handset data:
Internal number, password (entered in the PBX)
Open the Configuration > SIP page.
1.
Under General, enter the number of the SIP port in the Local
2.
port entry field.
Note: The standard port 5060 is already set up. Configure the
port according to the port configuration in the PBX.
Enter the PBX's IP address in the Default domain entry
3.
field.
Select the codec priority in the Codec priority list fields.
4.
30
COMfortel WS-400 IP - Setup V04 02/2016