Configuring The Ip Dect Server; Network Settings; Security Settings - Auerswald COMfortel WS-650 IP Inbetriebnahmeanleitung

– Knowledge of the access data (see chapter Commisioning >
Default settings when the equipment is supplied).
Start a browser (e.g. Mozilla Firefox).
1.
Enter the IP DECT server's IP address.
2.
Enter the user name in the User name entry field.
3.
Enter the password in the Password entry field.
4.
Click OK.
5.

Configuring the IP DECT Server

Requirements
– PBX with the following features:
available internal VoIP channels
i
configured internal SIP subscribers (telephone number,
i
user name, PIN/password)

Network Settings

Open the Configuration > General page.
1.
Select one of the following options from the Method list field
2.
displayed under IPv4:
Use Static IP Address: The IP DECT server is assigned
i
a fixed IP address (recommended).
DHCP assigned: The IP DECT server gets its IP address
i
automatically from a DHCP server.
Only for Use Static IP address:
3.
Enter the IP DECT server's IP address in the IP addr
i
entry field.
Enter the network mask in the Netmask entry field.
i
Enter the Gateway in the Gateway entry field.
i
Under NTP, enter the NTP server's IP address in the Server
4.
entry field.
Select the time zone from the Time zone list field.
5.
Click Save > OK > Reboot now > OK.
6.

Security Settings

Open the Configuration > Security page.
1.
COMfortel WS-650 IP - Setup and Quick Guide V03 07/2016
Commissioning
25