Kinderkraft COMFORT UP Bedienungsanleitung Seite 26

5.3 Securing the child car seat with vehicle's belt
The vehicle's 3-point
and Ill (15 kg- 36 kg).
The harness system must be removed from the seat (see point 5.1) when used for these age
groups 15 kg- 36 kg.
Place the child safety seat on the vehicles seat ensuring it is firmly pressed against the
Step 1:
car seat backrest (Fig. 5.3-1).
Seat your child In the child car seat
Step 2:
Step 3: Pull out the 3-point vehicle belt and place the lap belt on the opposite side of the buckle
under the armrest
under the armrest) The lap strap should be worn low down, so that the pelvis is firmly engaged
and the straps should not be twisted
(Fig. 5.3-3).
Place the diagonal belt goes through the Head belt guide (L) on the side of the headrest
Step 4:
Make sure that the belt is not t wist
(Fig. 5.3-3) and the diagonal shoulder belt in the direction of the automatic roll-up as possible
(Fig. 5.3-4).
The satisfactory position of the adult safety-belt buckle relative to the child car seat is as the
Fig 3-2. You can contact the child car seat manufacturer if in doubt about this point
5.4 Seat Cushion Instructions
Flat the backrest, lift up backrest at the junction of the base and backrest, separate the base
and the backrest (Fig.
Seat cushion is for 22 kg - 36 kg children, only use with 3-point seat
• Place the child seat firmly on car the seat to install (Fig.
• Let the children sit on the seat, the child's hips and back against the car seat
• Pull the car 3-point seat
ensuring that the shoulder belt is also put under the armrest)
5.4-6. Ensure that lap belt is worn as low down as possible, in order to make the child seat
and car seat tightly fit. The seat belt can't be twisted and put it into the buckle, you will
hear a sound of "click"
• Make sure the seat belt is not loose, not twi st
Ensure that any lap strap is worn low down, so that the pelvis is firmly engaged
6. Care instructions
6.1 Removing/ replacing the cover
• Remove the belt system as described in point 5.1.
• Press the backrest so far back so that it rests flat on the floor.
• Now you can remove the backrest.
; belt system may only be used to buckle up children of the age groups II
. (make sure that the diagonal belts and the lap belt on the buckle side are
ed.
5.4-1 and Fig. 5.4-2). Installation please reverse operati
belt, put the lap belt under the armrest of safety car seat (while
(Fig. 5.4-5).
EN
(Fig. 5.3-2).
. And allow it to the buckle in place
Tighten the adult belts in the direction as picture shows
ed.
26
. You will hear "click"
on.
belts.
5.4-3).
, tighten up the belt, see Fig.
.
. (Fig. 5.4-4)