Kinderkraft COMFORT UP Bedienungsanleitung Seite 23

• The seat cover should not be replaced with any other than the one recommended by the
manufacturer, because the cover constitutes an integral part of the restraint performance.
• The Instructions can be retained with the child
• Not to use any load bearing contact points other than those described in the instruction
and marked on the child car
• Any rigid items and plastic parts of the child car seat must be so located and installed that
they are not liable, during everyday use of the vehicle, to become trapped by a movable
seat or in a door of vehicle.
• Periodically inspect the harness, pay particular attention to attachment points, stitching
and adjusting devices.
• Do not continue to use the child car seat if parts have become damaged or have
loosened after an accident.
• In the event of an emergency it is important that the child can be released quickly. This
means that the buckle is not fully tamper proof and so your child must be taught never to
play with the buckle
• Ensure that all parts are locked in place correctly and not penned in the adjustable
or doors.
• Do not use this child seat at
used in your car
• We recommend using the baby car seat on the back seat of
• Before each journey check whether the child car seat is installed firmly.
• The back rest of the child car seat system have to rest flat against the back of the vehicle
seat. If necessary, adjust the head rest of the vehicle seat
• The buckle of the safety car seat belt can't too close to the below of ar mrest
the child restraint manufacturer if in doubt about this point (Fig.3-2).
• When you drive without a child in the child restraint system, always secure the system with
the adult belt.
4. Usage for the age group I
Use of the harness system is only permitted for children of age group I, which means from 9 kg
to 18 kg (approx. 9 months to approx. 4 years).
4.1 Setting the shoulder belt height (group I)
Check whether the
should be fed Into the belt
If the height of your shoulder belts in child car seat is not fit for your child. Adjust the height
of the shoulder belts, please proceed as follows:
loosen the harness (see point 4.3) Turn the child seat to the back (Fig.
Step 1:
Slide both of the harness off the harness connector (Fig. 4.1-3).:
Step 2:
Slide the belt off the chest pad connector. (Fig. 4.1-4).
Step 3:
Now you can pull both chest pads and shoulder belts forward through the belt slots
Step 4:
carefully (Fig. 4.1-5).
seat.
.
home.
.
shoulder belts are set at the right height for your ch
slots that lie at shoulder height or just above (Fig. 4.1-1).
EN
seat for its life period.
It's not designed for home use and should only be
23
cars.
.
.
ild. The shoulder belts
4.1-2).
seats
Please contact