Installation; Selection Of Installation Equipment - Rotel U1140CH Gebrauchsanweisung

• INSTALLATION

Selection of installation equipment

o Cut out the work surface according to the sizes shown in the drawing.
o For the purpose of installation and use, a minimum of 5 cm shall be maintained
around the hole.
o Be sure the thickness of the work surface is at least 30 mm. Please select heat-re-
sistant and insulated work surface material (wood and similar fibrous or hygroscopic
material shall not be used as a work surface material unless impregnated) to avoid
electric shock and deformation caused by the heat radiation from the hotplate as
shown below:
Note:
o The safety distance between the sides of the hob and the inner surfaces of the work-
top should be at least 3 mm.
L (mm) W (mm)
590 520
o Always make sure that the induction cooker hob is well ventilated and the air inlet
and outlet are not blocked. Ensure the induction cooker hob is in a good working
condition as shown below.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
H (mm) D (mm) A (mm) B (mm)
62 58
X (mm)
560 +4 490 +4 50 min.
+1 +1
111
F (mm)
3 min.