Rollei HS Freeze 2s Anleitung Seite 31

Warnings and safety instructions
• Do not discharge the flash at a very close distance to objects, people or animals.
Keep a minimum distance of approximately two metres. The flash releases inten­
se heat and may cause serious injury or damage.
• For photographic lighting purposes only. Not suitable for permanent room
lighting.
• Do not film car, bus, bicycle, motorbike or train drivers while driving this product.
The driver may be dazzled and cause an accident. This also applies to unlisted
persons or groups if possible glare could cause an accident.
• Do not shine directly into the eyes of people or animals as this may cause dama­
ge to the retina, visual disturbances and even blindness.
• Ensure adequate ventilation during operation. Never cover the ventilation slits of
the unit.
• Do not use or store the unit in high temperatures or in closed rooms exposed to
direct sunlight, and do not charge the battery while doing so. The product should
not be used in ambient temperatures above 40°C.
• Please note that the flash tube, modelling light and a connected reflector can be­
come very hot during operation. Do not touch these parts during or immediately
after operation. Allow the unit components to cool down before replacing the
flash tube or reflector.
• Handle glass parts such as the flash tube with care so that the glass is not
broken. Do not touch the flash tube with bare hands, use clean cotton gloves or a
microfibre cloth. Small residues of skin grease can cause the flash tube to burst.
• Make sure that the flash tilt lever is firmly tightened before using the unit and
connecting accessories to it.
• Mount the flash unit on a tripod with sufficient load­bearing capacity and set up
the tripod so that it cannot tip over or slip.
• For storage or transport, disconnect the battery from the flash unit.
• Allow the flash to cool down before packing it for transport or storage.
31