Troubleshooting - urmet domus Genya 1072 Bedienungsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Press button 2 to scroll the colour palette. Press button 1 to go back to palette selection.

There are 37 available colours are proposed as follows: light with colours traditionally used for panels

(emerald green, blue, amber, light green), switch-off, 33 customised colour lights. The LEDs will go out

at the end of the sequence. Press button 2 again to repeat the sequence from the beginning.

After selecting the colour, press the programming button to end the colour selection procedure.

NAME TAG LIGHTING LED

The power supply of the name card lighting leds must be the same used for the electrical lock (~0 ~12). The

door unit module jumper should be ﬁ tted as shown in the ﬁ gure.

Every calling station must have its own dedicated supply (~0 ~12): it is not possible to connect more

than one push-button panel to a single transformer.

DEFAULT PROGRAMMING

The device default settings are:

System type:

2nd edition

Station type:

main

Code format:

numeric (0001–9999)

Station number:

Off-hook waiting time: 40s

Busy time:

20s

Door opener time:

Led colour:

Green

To restore default settings, insert the programming device and hold bs button pressed for longer than three

seconds until you hear a beep. Alternatively, without the programming device, hold the programming button

pressed for longer than three seconds until you hear a beep.

VOLUME REGULATION

Volume levels are calibrated by default so not to require adjustments in most cases.

Use a screwdriver to adjust the trimmers if required.

CALLS

Up to 34 users can be called by pressing the corresponding buttons on the panels associated to the door

unit Ref. 1072/28. Additionally, a concierge switchboard Ref. 1072/42 can be called, simply by pressing a

call button associated to code 0000 during programming (day mode only). A courtesy ring, similar to that

generated on a called door phone, will be heard.

STAIRCASE LIGHTS FUNCTION

Press the button programmed for this function. A command will be sent to the special decoder and a

conﬁ rmation beep will be heard.

If the staircase lights button is pressed during the programming procedure, it will be reprogrammed with

the user code corresponding to the position.

BUSY FUNCTION

This function is only required in systems with more than one calling device. This function is used to ensure

that a conversation lasts sufﬁ ciently long following a call. An intermittent beep will be heard on the speaker

for the time before the busy time-out and the panel will be disabled.

Two cases can occur:

Busy time before the call user goes on-hook:

This is the maximum time for the user to lift the handset or open the door without loosing the call after the

ring.

Busy time after user goes on-hook:

This is the minimum guaranteed conversation time from when the handset is lifted.

AUTO-ON FUNCTION

This function is only available when the device is programmed as a main device with ID1. In this case, the

door unit will manage the auto-on command from the video door phones and output a call to the concerned

video door phone.