urmet domus Genya 1072 Bedienungsanleitung Seite 11

SIMPLIFIED PROGRAMMING
STATION NUMBER (ID)
The door unit and the door phones can be programmed without external devices in 2nd edition systems
consisting of main calling stations only (up to three). The following parameters can be programmed in this
case:
• Main station number: with dip-switch (1, 2, 3)
• Lock activation time: with LED button (1-30s)
• Door phone programming with LED button (predetermined user codes)
The two dip-switches determine the main station number as shown in the following table:
Dip-switch position
ON ON
1 2 1 2
ON
1 2
ON
1 2
ON
1 2
ELECTRICAL LOCK TIME
Press the programming button (3) and wait for the respective LED to come on.
Beeps will be repeatedly generated if there are other stations with the same ID. Press the button again to
quit the operation, correct the mistake with the dip-switches and repeat the operation.
Hold the "hall" button pressed for the time to be programmed (up to 30 s). The door unit will acquire the value
and a confi rmation beep will be heard. Press the programming button to return to normal operation.
The name tag light LEDs will go out when then electrical lock is operated.
BUTTON TYPE SELECTION
This selection is necessary only if the door unit is already installed on a Mod. 1128 casing. Use Jumper
1 of the door unit module Ref. 1128/44 or Ref. 1128/45 to select the type of buttons fi tted.
Jumper inserted to make small button panels
Ref. 1128/1 (default).
20
Main station number
Not defined
(for programming with
an external keyboard)
Station 1
Station 2
Station 3
Jumper not inserted to make large button panels
Ref. 1128/2.
DOOR PHONE PROGRAMMING
The door unit is programmed by default at the factory.
Consequently, the code-button association phase can be skipped in systems without secondary units. In this
case, go to the door phone programming procedure directly. The procedure consists of two steps:
A. Door phone booking (to be made on a calling station).
B. Door phone programming.
A.: Door phone booking (to be made on a calling station).
Press the programming button and wait for the respective LED to come on. Press the user buttons to be
associated with the door phones once. The booking sequence according to which the buttons are pressed
must be the same as the order in which the operator will go to the apartments.
DO NOT press the switchboard call button.
B.: Door phone programming.
1. Wait for 30s until the LED starts blinking.
2. Go to the fi rst booked user, hold the button pressed and lift the door phone handset. Two confi rmation
beeps will be heard and the LED will fl ash to indicate that it has been programmed.
3. Go to the other booked users and repeat the operations.
Refer to the attached sheet to remember the code/button association sequence.
IMPORTANT: The LED will start blinking if the buttons are not booked and no operation is carried out
for 30 seconds during the programming procedure. In this case, press the programming button to quit
programming. If required, press it again to resume programming.
Associating 2/3 door phones in parallel in 2nd edition systems using the simplifi ed programming
procedure
To install two or three door phones in one apartment and make them both ring when a call is received, press
the button related to the user twice or three times with the door phones in parallel when booking the door
phones.
When you reach the apartment where the parallel door phones are installed according to the programming
sequence, repeat the programming sequence on both door phones.
LED COLOUR
This function is only available if the door unit is installed in a Mod. 1128 casing.
On module Ref. 1128/44 or Ref. 1128/45, press the button to program the LED colours.
DS1072-031 DS1072-031
Button 1
LED colour
programming button
Button 2
21