Cleaning The Fluff Filter; Troubleshooting - STIEBEL ELTRON ETS 200 Bedienungsanleitung

oPErATIoN

Troubleshooting

5.1

Cleaning the fluff filter

Note
Clean the fluff filter in the air inlet grille regularly. This
will ensure trouble-free discharging of the appliance. If
a fluff filter is added, switch OFF the fan.
f Remove the air inlet grille from the catch springs by pulling it f
forwards at the bottom.
f Release the air inlet grille by pulling it out of the upper lock- f
ing mechanism.
2
1 Fluff filter
2 Air inlet grille
3 Studs
f Press the fluff filter out of the grille. Use, for example, a f
screwdriver for this.
f Clean the fluff filter with a brush or a vacuum cleaner. f
f Replace the fluff filter in the grille and click into place over f
the studs.
f Hook the upper edge of the air inlet grille on to the locking f
screws.
28 | ETS 200-700
f Press in the air inlet grille over the catch springs. f
6. Troubleshooting
Problem
The appliance does not
heat up.
The heat transfer of the
appliance is too high
even in mild weather.
Appliance does not dis-
charge.
1
Note
Changes or removal of faults at the charge control system
only become apparent after renewed charging.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-000000).
3
Cause
f remedy
The charge was not set or Set the "charge control"
was set too low. rotary selector higher.
No power supply. Check the fuse/MCB and
the RCD in the domestic
distribution board.
The setting at the charge Adjust the settings.
control system and/or
charge controller is in-
correct.
The fluff filter is clogged. See chapter "Cleaning,
care and maintenance".
Typ: ETS 700 373 kg
Nr.: 074489 - 8252 - 000194
3/N/PE ~ 400V 50 HZ
5,25 5,83 6,42 7,00 6,75 7,50 8,24 9,00 kW
5 6 7 8 9 10 h
1/N/PE ~ 230V 50 HZ
1,5 kW
26 W
171671 -34511
Made in Germany
*0744898252000194K*
www.stiebel-eltron.com