Maintaining And Cleaning Magicsafe - Waeco MagicSafe MS620 Montageanleitung Und Bedienungsanleitung

MS-620.book Seite 78 Dienstag, 18. Oktober 2005 3:04 15

Maintaining and cleaning MagicSafe

10.5 Programming a new remote control
MagicSafe can be operated with up to four remote control units.
Proceed as follows to program a new remote control:
➤
Switch the ignition on and off twice.
➤ Switch on the ignition again within 7 s.
✓ The status LED flashes for 3 s. Afterwards there is a pause of 1 s.
➤
Count how often the status LED flashes and switch off the ignition when the number
of flashes corresponds to your PIN code.
➤ Switch the ignition on again.
➤
Press button 1 (see Fig. 7, page 6) on the remote control to be programmed.
➤
Switch the ignition off for 10 s, to exit the programming function
or ...
Switch the ignition on again to program the software functions.
10.6 Registering a MS-650PIR movement sensor
MagicSafe can be operated with two optionally-available MS-650PIR movement sensors.
Observe the separate installation instructions for the MS-650PIR movement sensor.
To register a new MS-650PIR movement sensor, proceed as follows:
➤
Open the lid on the bottom of the movement sensor.
➤
Switch all of the mini-switches on the switch block to OFF.
➤ Insert a 9 V battery (not included in the scope of delivery).
➤
Switch the ignition on and off twice.
➤
Switch on the ignition again within 7 s.
✓
The status LED flashes for 3 s. Afterwards there is a pause of 1 s.
➤
Count how often the status LED flashes and switch off the ignition when the number
of flashes corresponds to your PIN code.
➤
Switch the ignition on again.
➤
Press the Learn button of the new movement sensor.
➤
Switch the ignition off for 10 s, to exit the programming function
or ...
Switch the ignition on again to program the software functions.
11 Maintaining and cleaning MagicSafe
Caution!
Do not use sharp or hard objects to clean the device as these may damage
the components.
78
MagicSafe MS620