Warning Signals - Waeco MagicSafe MS620 Montageanleitung Und Bedienungsanleitung

MS-620.book Seite 74 Dienstag, 18. Oktober 2005 3:04 15
Using MagicSafe
9.10

Warning signals

The following tables lists all of the MagicSafe warning signals
Action
You are activating the
alarm system.
You are deactivating the
alarm system.
You are switching the
ignition on.
The following table lists the meanings of the signals of the status LED:
Number of warning signals Cause
2
3
4
5
74
Warning signal
The hazard lights flash three
times.
The alarm siren sounds three
warning signals.
The hazard lights flash four
times.
The alarm siren sounds four
warning signals.
The status LED gives warning
signals.
Shock sensor
Doors
Programmable input (if software function 9 "Programmable
additional input" is set to "Engine bonnet")
Ignition
MagicSafe MS620
Meaning
A door or a cover is not closed prop-
erly.
➤ Find which door or cover is open
and close it.
Break-in alarm
An alarm was triggered after you
activated the alarm system.
➤ Check the vehicle for damage.
The status LED displays which sen-
sor triggered the alarm (see following
table).