Waeco MagicSafe MS620 Montageanleitung Und Bedienungsanleitung Seite 59

MS-620.book Seite 59 Dienstag, 18. Oktober 2005 3:04 15
MagicSafe MS620
Brown/white (P2.7)
➤
Connect this cable if necessary to the optional start block relay.
The output switches to earth when the alarm system is activated and may conduct a
maximum of 200 mA.
7.4 Connecting the status LED (P3)
➤
Insert the plug of the status LED into the P3 connection (see Fig. 6, page 6) in the
control device.
7.5 Connecting the shock sensor (P4)
➤
Insert one of the two plugs of the shock sensor cable (fig. 4.10, page 5) in the shock
sensor connection.
➤ Insert the other plug of the shock sensor cable (fig. 4.10, page 5) in the P4 connec-
tion (see Fig. 6, page 6) in the control device.
7.6 Vehicle specific data
Check the polarity before connecting.
The following table is not intended to be understood as being complete. You can obtain
information on other vehicles on request from WAECO.
We reserve the right to make alterations.
Electrical connections
59