Technical Description; Functional Description - Waeco MagicSafe MS620 Montageanleitung Und Bedienungsanleitung

MS-620.book Seite 51 Dienstag, 18. Oktober 2005 3:04 15
MagicSafe MS620
5

Technical description

5.1

Functional description

MagicSafe MS620 is an alarm system which is equipped with a shock sensor and an
alarm siren. MagicSafe offers many useful functions, some of which you may have to
adapt to a system which is already installed in the vehicles.
MagicSafe MS620 offers the following functions:
Integration in a central-locking system already installed in the vehicle
The alarm system can operate an existing central-locking system.
Programmable output for convenience functions.
This enables you to use the remote control to close the sun roof and electrically oper-
ated windows, switch on the parking heater or main beam or to unlock the boot or
petrol tank lid.
Programmable input for connecting a contact switch to the engine bonnet, the boot
or additional door contacts.
Automatic reactivation
If you switch off the alarm and do not open a door or cover panel within 30 s, the
alarm system activates itself again automatically.
Self-activation
If you leave the car and do not open a door or panel within 30 s, the alarm system
can activate itself automatically.
Service mode for inspections and repairs
In service mode, all settings for the alarm system remain stored, even if the battery
is disconnected.
Panic mode
You can trigger the alarm via remote control, if you are attacked – to scare off the
attacker.
Vehicle search function
You can use the alarm system to indicate the location of your vehicle optically and
acoustically. The alarm siren sounds and the hazard lights flash.
Some functions have been installed as options and have to be configured or programmed
during installation.
The microprocessor-controlled MagicSafe alarm system protects vehicles and their con-
tents from theft. If the alarm system is activated, an alarm is triggered as soon as the door,
boot or bonnet are opened, the ignition turned on or the shock sensor detects impacts or
blows to the vehicle.
An ultrasonic module with sensors can be installed instead of the shock sensor for mon-
itoring the interior of the vehicle. The device is available as an accessory.
The alarm system has been designed for vehicles with an on-board voltage of 12 V. The
input for the door contact switch can be used for both positively and negatively charged
door contacts.
Technical description
51