Status Displays - Waeco MagicSafe MS620 Montageanleitung Und Bedienungsanleitung

MS-620.book Seite 52 Dienstag, 18. Oktober 2005 3:04 15
Technical description
The programmable input can be connected to the bonnet contact switch, the boot contact
switch or additional door contacts. This additional input can be programmed so that it
does not trigger the complete alarm rather a short pre-alarm.
When MagicSafe is activated, it closes the central locking (if present), when it is deacti-
vated, MagicSafe opens it again. MagicSafe signals this with a optical signal via the vehi-
cle indicators, an acoustic signal via the siren and also switches a status LED on or off as
a further indication.
MagicSafe is operated with a two-button remote control. If the batteries are empty or the
remote control is lost or damaged, you can turn the alarm system off with your PIN code.
You can program new or additional remote control systems to the alarm system.
In addition to this you can alter the software functions of the remote control.
To ensure that a potential thief cannot read the deactivation code, the code transmitted
by the remote control is generated anew using a random generation process after every
activation.
5.2 Possible operating modes of MagicSafe
The alarm system has the following three operating modes:
Stand-by
The alarm system is constantly on stand-by as soon as it is installed and correctly
connected. It cannot trigger the alarm when in stand-by.
Activated
If the alarm system is activated, it can trigger the alarm. This happens if someone
breaks into the door or if the vehicle is rocked, for example. If you wish to drive off,
you must first deactivate the alarm system. The system is then in stand-by mode.
Alarm triggered
If the alarm is triggered, you can switch off the alarm and then either leave the alarm
activated (activated mode) or deactivate it. The system is then in the stand-by mode.
5.3

Status displays

The status LED displays have the following meanings:
Condition
Activated
Deactivated
Being activated/alarm
Service mode
PIN code alteration
52
Status LED display
Slow flashing
Off
Quick flashing
Constant glow
Flashing
MagicSafe MS620