Troubleshooting; Disposal - Conrad 55 14 52 Bedienungsanleitung

All manuals and user guides at all-guides.com

13. Troubleshooting

Clear water pump does not take in water
• Open a shut-off valve on the pressure side if present, because air cannot escape
• Clean intake openings (disconnect clear water pump from the mains voltage first!)
• Water level too low (minimum level approx. 5 cm); only air is taken in
The clear water pump does not start up or stops in operation
• Check power supply
• Impeller inside the pump is blocked by contamination (disconnect pump from mains voltage, remove hose and flush
inside of the pump)
• Water level too low (minimum height approx. 5 cm) and rotary button in position "AUTO", so that the clear water
pump is not activated
• The overload protection triggered. Disconnect the clear water pump from the mains voltage and remove the cause
for the overload (e.g. intake opening clogged, water too deep, etc.).
• The overtemperature protection triggered. Disconnect the clear water pump from the mains voltage and let the clear
water pump cool off. Remove the cause for triggering (e.g. water temperature too high, running dry too long, etc.).
Conveyed volume drops
• Check intake openings, remove contamination if required
• Clear water pump sucks in air because the intake openings are not completely submersed anymore
• Check hose attachment to the hose adapter
• Check hose for leaks
Float switch does not trigger or does not switch off
• Check if the rotary button is put in the position "MANUAL"; the float switch is deactivated
• The clear water pump must only be operated as vertically as possible for the float switch to work correctly
• Dirt blocks the float switch; disconnect the clear water pump from the mains voltage and flush it with a garden hose

14. Disposal

At the end of its service life, dispose of the product according to the relevant statutory regulations.
26