Behringer ULTRACURVE PRO DEQ2496 Schnellstartanleitung Seite 12

12
ULTRACURVE PRO DEQ2496
ULTRACURVE PRO DEQ2496 Controls
Controls
(EN)
(1) (3) (6)
(2) (5) (4)
(1) The LED METER indicates the DEQ2496's input signal. The top CLIP LED lights
up as soon as the input signal level is too high or the peak limiter in the
Dynamics menu has been activated.
(2) Use the METER key to select the METER menu.
(3) The DEQ2496 features a built-in real-time analyzer displaying the entire
frequency range. Use the RTA key to select the corresponding menu and
adjust the various settings.
(4) Depending on the currently selected menu, the COMPARE key allows you to
compare either complete presets or individual modules. The following table
shows how the COMPARE key works in each module.
COMPARE
(complete preset)
GEQ
PEQ
DEQ
x
FBD
WIDTH
DYN
x
UTIL
I/O
x
BYPASS
not active
RTA
x
MEMORY
not active
METER
(8)
(7)
COMPARE
(module only)
x
x
x
x
x
x
(9)
(5) Press the MEMORY key to select the MEMORY menu. Here, you can save or
recall complete presets or individual modules from one preset (e.g. GEQ,
PEQ etc.). The MEMORY LED lights up as soon as the parameter values of the
preset selected in the MEMORY menu differ from currently active settings.
(6) The PAGE key allows you to select the various pages within one menu.
(7) The functions performed by the keys A and B depend on the selected menu
and are indicated in the display.
(8) This is the LC display of your ULTRACURVE PRO
(9) The DEQ2496 has three DATA WHEELS, which can be used to select and edit
various parameters—again depending on the currently selected menu.
Often, they perform a dual function, i.e. you can edit by turning and pressing
a data wheel. Pressing the data wheels also changes the scaling of many
parameters (step width) or confirms/resets previously made entries.
(10) With the menu keys you can select the individual menus of the various
modules. They can also be used to select specific pages from these menus
(like PAGE key). Each of these keys has a built-in LED, which lights up when
the corresponding module starts modifying the sound. When the DEQ2496
receives MIDI data, the LED of the UTILITY key lights up briefly. Keep this key
pressed for about 1 s to bypass active modules or re-activate disabled ones.
This function refers only to those modules which can be edited in the
BYPASS menu.
(11) Use the POWER switch to put the DEQ2496 into operation. This switch
should be set to "Off" before you connect the unit to the mains.
(10) (11)