Specifications - Makita GD0800C Bedienungsanleitung

ENGLISH (Original instructions)

SPECIFICATIONS

Max. wheel point size
Rated speed (n) / No load speed (n
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change with-
out notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745:
Model GD0800C
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Model GD0810C
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745:
Model GD0800C
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model GD0810C
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
Model
Collet size
Max. wheel diameter
Max. mandrel (shank) length
)
0
Net weight
Safety class
) : 78 dB(A)
pA
) : 77 dB(A)
pA
2
) : 4.5 m/s
h
2
2
) : 2.5 m/s or less
h
2
GD0800C
8 mm max.
25 mm
46 mm
-1
28,000 (min )
371 mm
1.7 kg
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared emission
value depending on the ways in which the tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Die Grinder
Model No./ Type: GD0800C,GD0810C
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3 ENGLISH
GD0810C
8 mm max.
50 mm
46 mm
7,000 (min
371 mm
1.7 kg
/II
28.2.2015
Yasushi Fukaya
Director
-1
)