Gb Starting Locomotive Operation; Maintenance Of The Model - roco RAILLOGIX 193 Bedienungsanleitung

GB
Starting locomotive operation
Unwrap model: Take out the model cautiously
ith foil (fig. ).
Operating instructions: Before use is advisab-
le to let the loco go around about 30 minutes for-
ards an 0 minutes back ards ithout load, to
obtain an optomal circuit and best tractive power.
The smallest radius this model should run is R2 of
the ROCO track system (R2 = 358 mm).
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no. 46400, Roco track cleaning van, or item
no. 10002, Roco track cleaning rubber, for
removing heavy dirt.
More information about the sound decoder can be found here
Drivers Cab 2 ON
Position "ON"
Works setting: The headlight is illuminated in the analogue and digital operations, depending on the
direction of travel.
14
Fittings: Operation is possible with different
couplings (fig. 2). e recommend using the oco
close coupling.
n the enclosed accessory bag you ill find small
kits to be fitted on your locomotive. lease mount
them cautiously.
Attention! se glue only if indicated (fig. 2
Running in digital mode:
Remove the jumper from the interface.
Finally put the plug of the chip into the interface
as sho n in fig. .
A.C. operation: see fig.
ON
Drivers Cab 1 ON
1 2
GB

Maintenance of the model

To en oy your model for a long time, it is neces-
ary to service it regulary (i.e. after it has been in
ope-ration for approximately 30 hours).
1. Cleaning of wheel contacts: Wheel cont-
acts easily get dirty on tracks which are not en-
tirely clean. Use a small brush to remove dirt
). from spots marked in fig. . rior to cleaning the
contacts dismantle the bogie (fig. ).
2. Lubrication: Apply tiny oil drops to spots
marked in fig. . rior to lubrication dismantle lo-
comotive (fig. 4). e recommend using item no.
10906, Roco oiler. For lubrication the gearparts
(e.g. cog heels, orm) e hould recommended
our Roco special grease (item no. 10905).
Attention: Please do not oil these parts when
using our grease.
Position „OFF"
In the analogue operation, the headlight is deactivated.
3. Change of traction tyre: Remove the gear
cover (fig. ). Take out wheel set and remove
traction tyre using a pin or a fine scre driver
(fig. ). hen pressing on the ne
please avoid twisting it.
4. Carbon Brush Changing: First remove loco
body (fig. 4), and then the motor (fig. 0).
Assembly: During assembly please take care of
correct position of contacts.
ON
Drivers Cab 2 OFF Drivers Cab 1 OFF
1 2
traction tyre
3