Assembly Instructions - Makita BHX2501 Betriebsanleitung

ASSEMBLY INSTRUCTIONS

CAUTION : Before performing any work on the blower, always stop the
engine and pull the spark plug connectors off the spark
plug.
Always wear protective gloves!
CAUTION : Start the blower
completely.
1. ASSEMBLY OF BLOWER PIPES
1) Align grooves in the blower pipe with pegs on the blower housing
and slide the pipe onto housing.
2) Turn the blower pipe clockwise to lock it into place.
3) Place clamp around the opening of the blower pipe. Fasten se-
curely with bolt and nut
2. ASSEMBLY OF VACUUM ATTACHMENT
1) Installing Vacuum pipe (nozzle)
(1) Loosen the screw and open the protector
WARNING!
When using the blower for blowing operation, always close the
protector and tighten the screw
Otherwise the bare impeller may catch your body or clothing
and cause serious injury.
Always use the vacuum pipe A and B together. Otherwise
contact with the impeller may cause serious injury when the
operator attempts to remove jammed debris in the pipe.
(2) Align " " mark on the vacuum pipe A and B. Insert the vacuum pipe
A into the vacuum pipe B until three latches snap in.
(3) Align the indicated on the vacuum pipe A with the " " indicated
on the blower. Then insert the vacuum pipe into the blower.
(4) Turn the vacuum pipe until the
on the blower to lock the vacuum pipe.
(5) Fasten the vacuum pipe securely to the blower with screw
bracket . Do not tighten the screw too much to avoid parts breakage.
Caution: Do not perform the fastening operation in (5) above if the blower
is to be used in a country or region where the CE mark is not
applicable.
Note: The engine will not start unless the vacuum pipe is mounted
completely.
2) Installing Elbow and Dust Bag
(1) Open the fastener of the dust bag.
(2) Insert the elbow's railed side into the dust bag, take it out through the
bag's entry.
(3) Fasten the elbow with hook-and-loop fastener around the place
indicated in the fi gure.
CAUTION
Install the dust bag away from railed side of the elbow. If
the dust bag is placed near the engine, the exhaust gas may
scorch the dust bag.
(4) Install the elbow on the blower.
(5) Place clamp around the opening of the elbow. Fasten securely with
bolt and nut .
Caution: Do not perform the fastening operation in (5) above if the blower
is to be used in a country or region where the CE mark is not
applicable.
WARNING!
Do not attempt to pick up large wood chips, metals, glass,
stones, liquids, lighted cigarettes, fi re works or the like.
only after having assembled
.
.
before operation.
is aligned with the " " indicated
it
and
8