Safety Notes; Installation Instructions; Technical Data; Symbol Description - HANSGROHE PuraVida 15275400 Gebrauchsanleitung Und Montageanleitung

6

Safety Notes

6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The shower system may only be used for bathing,
hygienic and body cleansing purposes.
6 The hot and cold supplies must be of equal pres-
sures.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms!
• The mixer can not used together with a continuous
flow water heater.
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• If the water is flowing along the fixture in the direction
of the shaft, the spray former must be replaced with a
standard air bubbler 13913000.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
anti-pollution function
The product is exclusively designed for drinking water!
4
English
max. 1 MPa
0,25 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
max. 70°C / 4 min
Assembly see page 31

Symbol description

Do not use silicone containing acetic acid!
Dimensions (see page 33)
Flow diagram (see page 33)

Rate of flow mixer

Rate of flow handshower
Operation (see page 34)
• Hansgrohe recommends not to use as
drinking water the first half liter of water
drawn in the morning or after a prolon-
ged period of non-use.
• Due to the design of the Bidette fittings,
a small amount of water will leak at the
outlet of the fitting when the hand shower
is running.
Cleaning
see enclosed brochure.
Spare parts (see page 36)