Ejecting A Cd; Connecting/Removing A Usb Data Carrier; Selecting Tracks; Select A Folder/Cd (Only In Mp3/Wma/ C'n'c Or Cd Changer Mode) - Blaupunkt san francisco 300 Bedienungs- Und Einbauanleitung

Ejecting a CD

Notes:
• If a CD is ejected and not removed, the
drive will automatically draw it back in
again after approx. 10 seconds.
• You can also eject CDs while the car sound
system is switched off or whilst another au-
dio source is activated.
button : to eject an inserted
u
Press the
CD.
Connecting/removing a USB data
carrier
To be able to connect a USB data carrier, the sup-
plied USB cable must be connected to the car
sound system (see Installation Instructions).
u
Switch of the car sound system so that the
data carrier will be correctly registered and
unregistered.
u
Connect the USB data carrier to the USB
cable or pull it off.
If a USB data carrier is connected, the display
shows the USB symbol. If the USB data car-
rier is initially selected as audio source after
connecting it or after switching on the car
sound system, the data are read in fi rst (the
display shows "READING" during this time).
Notes:
• If the connected USB data carrier cannot be
seen, "USB ERROR" is briefl y displayed.
• The time required for reading in the data
depends on the design and size of the USB
data carrier.

Selecting tracks

u
Briefl y press the button
change to the previous/next track.
Note:
If the current track plays longer than 3 sec-
5 once restarts the track.
onds, pressing
Select a folder/CD (only in MP3/
WMA/C'n'C or CD changer mode)
u

Fast searching

u

Interrupting playback

u
Playlist mode (only in MP3/WMA
mode)
The car sound system can play playlists that were
created with an MP3 manager, such as WinAmp
or Microsoft Media Player. The playlists must be
stored in the root folder of the CD or USB data car-
rier. The following playlist formats can be recog-
nised: M3U, PLS.
Selecting tracks in Playlist mode
u
u
5 / > to
u
CD/MP3/WMA/C'n'C/CD changer mode
@ /
Press the button
the previous/next folder or CD.
Note:
This also allows you to change between
playlists of a device connected via C'n'C.
Press and hold down the button
until the desired position has been reached.
Press the button 3
playback ("PAUSE") or to continue.
Press the 2 button < for approx. 2 seconds
to change to the Playlist mode:
"LIST MODE" briefl y appears on the display.
The fi rst track of the fi rst playlist is played.
Note:
If the data carrier does not contain any
playlists, "LIST MODE" is briefl y displayed.
Briefl y press the button
change to the previous/next track of the cur-
rent playlist.
@ /
Press the button
the previous/next playlist.
The display briefl y shows the name of the
selected playlist, and the fi rst track of the
playlist is being played.
2 to change to
5 / >
< to interrupt the
5 / > to
2 to change to
33