Cycle End - hanseatic HWD96T314CE Gebrauchsanleitung

Page EN-20 Operation: Standard cycles
Suspending and continuing
the cycle
• If you want to stop the cycle, for example
to put in additional washing, press the
button (7).
The remaining time display (4) will flash
during the interruption.
Depending on how far along the cycle is,
– the loading door will be unlocked:
– the loading door will remain locked: .
• Press the button (7) again to continue
the cycle.
Please note that a long pause can affect
the wash result, since the suds cool
down.
Suspending/altering the cycle
1. Turn the cycle selector (2) to "Off" to can-
cel an active cycle or to select an alterna-
tive cycle.
The programme ends.
2. Set the cycle selector (2) to any other cy-
cle in order to drain the soapy water.
The suds will be drained away.
3. To select a new cycle, set the cycle selec-
tor (2) to a new cycle.
4. If required, add extra detergent.
5. Start the new cycle with the
If you have suspended the cycle during
the drying phase, you should leave the
laundry to air out so that it can continue to dry
and cool off.

Cycle end

The appliance stops automatically as soon
as the selected cycle is finished. In the time
field (4), "Ende" will be visible.
If no further settings are made, the appliance
will automatically switch off after 15 minutes.
1. Turn the cycle selector (2) to "Off".
2. If the
can be opened and you can remove the
laundry.
3. Leave the loading door (15) open and pull
the dispensing drawer (1) out slightly to
allow the inside of the appliance to dry.
4. Turn the tap off.
5. Disconnect the mains plug from the socket.
button (7).
symbol lights up, the loading door