hanseatic HWD96T314CE Gebrauchsanleitung Seite 52

Page EN-8 Safety notices
CAUTION!
Risk of burns!
Improper handling of the appliance
can lead to burns.
■ The glass of the loading door can get
hot during operation. Do not touch
the glass when the appliance is run-
ning.
■ Do not touch the water outlet hose
during pumping. Do not touch the
rear wall during the drying process.
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■ Fix the water outlet hose properly to
the sink or bath to prevent it from
slipping due to the recoil caused by
pumping. Adhere to the maximum
height of 100 cm!
■ If the water outlet hose is fi xed to
the edge of the drain or bath, do not
use the drain or bath whilst the wash-
er-dryer is in operation.
■ Do not touch the outlet hose during
pumping as the suds may be hot.
■ For drains make sure that the cross
section of the discharge pipe is great
enough that the drain cannot over-
fl ow.
■ Leave the suds to cool before drain-
ing them (e. g. during emergency
draining).
■ Never open the loading door with
force.
Risk of injury!
Improper handling of the appliance
may result in injury.
■ The appliance is very heavy. Never
transport or carry the appliance alone;
always with the assistance of another
person.
■ Remove all obstacles on the transport
route and from the installation loca-
tion, e.g. open doors and clear away
objects lying on the fl oor.
■ Do not use the loading door as a step,
seat or for support. Make sure that
children and pets do not stand or sit
on the open loading door.
■ Take care to prevent any risk of trip-
ping when laying out the mains cord
and hoses.
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■ If a trolley is used to move the ap-
pliance, the appliance must be lifted
as shown on the packaging. Always
transport the appliance vertically.
■ Do not use any sharp or pointed ob-
jects when unpacking the appliance.
■ Do not use the loading door or the
dispensing drawer to pull or lift the
appliance.
■ Remove all packaging material be-
fore fi rst use.
Make sure the appliance is not con-
nected to the power supply whilst the
transport safety devices are being re-
moved or installed.