Knife With Smooth Edge; Knife With Serrated Edge; Scissor Sharpening; Flat-Head Screwdriver - Silvercrest SEAS 20 B1 Bedienungsanleitung

Knife with smooth edge

If you have selected the setting „Knife with smooth edge"
■ Always sharpen knives with a smooth edge on both sides – for
this, left and right side sharpening guides are available.
■ In the left guide hold the knife inclined to the left, and in the right
guide inclined to the right, whilst drawing the blade through.

Knife with serrated edge

If you have selected the setting "Knife with serrated edge"
■ Sharpen these only on the side with the serration – the draw
through direction for the knife is dependant on which side of the
blade this is on. The side with the serrated edge must be pointing
in the direction of the grindstone
■ In general, serrated blades can only be sharpened up to a point.
Knifes with a fine sawtoothing (e.g. table knives) do not require
sharpening.

Scissor sharpening

If you have selected the setting "Scissor sharpening"
■ Sharpen both scissor blades one after the other. For this, open the scis-
sors out and draw both blades, one after the other, through the guide.

Flat-head screwdriver

Should you wish to grind a slot-screwdriver
■ This is possible in every position of the function and protective
cap . Appropriate to its width, insert the screwdriver through
one of the two grinding openings
and protective cap
screwdriver will now be ground level and flat.
SEAS 20 B1
during sharpening.
on the front of the function
(see fold-out side). The end face of the
(Fig. B):
(Fig. C):
(Fig. D):
flat (Fig. E):
GB
43