Abduction Block - Thomashilfen RECARO Monza Nova 2 Reha Gebrauchsanweisung

Instructions for Use – RECARO Monza Nova 2 Reha
Belt buckle:
Press the red dent of the buckle to open. Separate the two upper belt fasteners. To close the belt, put the belt fasteners
into the buckle and push together until they lock in place with an audible „Click".
The cover for the crotch pad (zipper) can be removed and washed in the machine at up to 30° C / 86° F. Please undo
the zip on the bottom crotch pad as well to remove the cover.
Fig. 4: Opening and closing the belt buckle („Click")
Headrest
Adjust the seat's headrest to the highest position to facilitate attaching the headrest. Pull the covers of the supports over
the side parts of the headrest and fasten them at the top with the press button. The pads are fastened to the lower part
of the headrest with an elastic rubber band.
Fig. 5: Attaching the headrest / Fig. 6: Fastening at bottom
Fig. 7: Fastening at top
Lateral trunk supports
The lateral trunk supports can be fastened at 3 different heights on the left and right in the back area with press buttons
and hook and loop. Start with the press buttons.
The supports can be fixed more firmly by pressing against the fleece strips in the back of the seat.
Fig. 8: Press button / Fig. 9: Hook and loop-fastening
Lateral seat supports
Adjust the backrest to a horizontal position to facilitate attachment of the lateral supports. Pull the covers of the lateral
supports over the side parts of the seat surface and attach them to the rear of the seat surface with the press button.
Fig. 10: Attaching the support / Fig. 11: Press button, rear

Abduction block

The abduction block can be adjusted in depth. In order to do so, it first has to be released from the groin belt. Remove
the belt strap end piece from the end of the groin belt and unthread the belt from the sliding buckle and belt buckle.
Pull the abduction block up and off the groin belt.
Thread the groin belt back through the sliding buckle and belt buckle, and secure the loose end of the belt with the belt
end piece. Position the abduction block as needed on the hook-and-loop fastener provided on the seat bottom.
To remove the cover, the abduction block first has to be released from the groin belt as described above.
Fig. 12: Belt end piece / Fig. 13: Removing the belt end piece
Fig. 14: Unthreading the sliding buckle and belt buckle / Fig. 15: Removing the abduction block
For the following setting options / performance features, please refer to the separate RECARO Monza Nova 2 instruc-
tions for use.
Model Seatfix (Fig. 16)
Isofix (LATCH) is an internationally standardised fastening system for children car seats. Corresponding Isofix anchor
points are firmly connected to the vehicle's bodywork. With Isofix children car seats can be quickly and easily ancho-
red in these standardised fixture points. In this way, the seat is safely secured in the vehicle, even without a child and
does not have to be retained with the 3-point vehicle belt. Please check beforehand whether your car has an Isofix
anchor point.
21
2021-04