Installation; Installing (Or Replacing) The Battery; Setting Up Your Phone; Set Time/Date - Maxcom KXT480 Bedienungsanleitung

4

INSTALLATION

1. Locating the Base unit
The Base unit should be placed on a level surface, in a position where:

the telephone line cable will reach your telephone line socket or extension socket.

it is not close to a sink, bath or shower, or anywhere else where it might get wet.

it is not close to other electrical equipment - fridges, washing machines,
fluorescent lights, etc.
2. Plug the coiled handset cord into the Handset.
3. Plug the other end into the jack on the left side of the Base unit.
4. Place the Handset in the Base unit.
5. Plug the telephone line cord into the socket at the back of the base and the other end into your
telephone line socket.
6. Lift the Handset and check for Dial tone in the earpiece.
4.1

Installing (or Replacing) the Battery

IMPORTANT
Before removing the battery compartment cover, always make sure the base unit is disconnected from the
telephone line.
Install 2 pcs of Alkaline AAA batteries into the battery compartment and
Note:
 Please do NOT use Rechargeable batteries in this phone.
 Batteries are not included with the unit.
 The battery life is typically about 6 months, depending on
usage.
When the battery is low
side of the display screen. If you do not replace the batteries,
they will become totally discharged and your display screen will
not work and you may lose all the telephone memories and settings.
5

SETTING UP YOUR PHONE

Press the SET/STO button to enter the menu and then use
options:

SET 1 DATE

SET 2 LCD

SET 3 FLASH
Note: The system will time out if you leave more than 8 seconds between key presses.
5.1

Set Time/Date

You will need to set the correct time and date so they can be displayed correctly on the display.
If you subscribe to a Caller Display service, the time and date will be set automatically on receipt of your
first incoming call, but you may still need to set the correct year
IN STANDBY MODE, PRESS SET/STO BUTTON
1
Press SET/STO button to confirm
2
Press
3
Press SET/STO button to confirm.
4
will flash in the middle on the right
The display shows ' SET 1 DATE '.
The 'year' icon will be blinking"
button to set the year
UP or DOWN
The 'month' icon will be blinking
re-fit the cover before use
UP DOWN
or buttons to cycle through the following
.
.
.
17
microwave ovens, TVs,
ENGLISH