Service And Spare Parts - OEG 650 001 082 Montage- Und Bedienungsanleitung

Contact your local plumber for all service questions.
Error
Motor does not start.
Motor does not reach full speed.
Motor overheats.
Pump does not deliver any water.
Pump capacity too low.
Pump pressure too low.
Pump pressure too high.
Pump and motor too loud.
Water leakage at shaft.
Air bubbles at fittings
or connections.
Swimming pool pump
Cause
1. Device is disconnected from power supply
2. Thermal overload protection triggered
3. Blocked motor shaft
4. Motor windings burned out
5. Defective start switch inside the motor
6. Defective wiring
7. Low voltage
1. Low voltage
1. Low voltage
2. Inadequate ventilation
1. Pump is not primed
2. Closed valve in suction and discharge line
3. Leakage or air in suction system
4. Impeller clogged
1. Valve in suction and discharge line partly closed
2. Suction and discharge line partly clogged
3. Suction and discharge line too small
4. Pump runs at reduced speed (see above)
5. Clogged basket in skimmer or hair and lint strainer
6. Dirty filter
7. Clogged impeller
1. Pump runs at reduced speed (see above)
2. Discharge valve or inlet fittings closed too far
1. Discharge valve or inlet fittings closed too far
2. Return lines too small
3. Dirty filters
1. Clogged basket in skimmer or hair and lint strainer
2. Worn motor bearings
3. Valve in suction line partly closed
4. Suction line partly clogged
5. Suction hose clogged or too small
1. Shaft seal requires replacement
1. Air leakage in suction line at connections or fittings
2. Cover gasket of hair and lint strainer needs cleaning
3. Restriction in the suction line
4. Low water level in the pool
9

Service and spare parts

Troubleshooting
GB
10
11