Interfaces - Heidolph Hei-VAP Industrial Betriebsanleitung

Device description

Interfaces

The device interfaces are located on the bottom of the device display:
– 1×USB 2.0, max. 500 mA
– 1× LAN RJ-45 (not working in the current device version)
WARNING: Electric Shock
If the interfaces are assigned too high voltages and are not suffi-
ciently insulated, metallic parts such as the housing can be under
voltage in the event of a fault.
Safely separate low-voltage inputs and outputs via 25 V AC or 60 V
DC according to DIN EN 61140, or by double or reinforced insula-
tion according to DIN EN 60730-1 or DIN 60950-1.
Use only shielded connection cables. Connect the shield to the
connector housing.
CAUTION: Damage to the device
Make sure that the device interfaces on the bottom of the display
are always properly covered!
Penetrating fluid can cause interface malfunctions and short-circuit.
95