Self Diagnostics Failure Code Explanation; Installation Instructions For Stacking - Panasonic NE-2153-2 Bedienungsanleitung

Self Diagnostics Failure Code Explanation

This oven monitors its operation and displays a Failure Code in the Digital Display Window when a problem occurs.
What to do when a failure code appears:
Unplug the oven and wait more than 10 seconds before reconnecting.
If normal operation does not resume, follow next chart.
CODE
F01 Temperature of exhaust air too High
F33 Defective Thermistor Circuit
F44 Defective Control Panel
F81–82 Defective Relay Circuit
F86–87 Defective Relay Circuit
U30 Memory cooking has exceeded the maximum time during
double quantity and triple quantity setting.
1. Oven shuts off automatically. Disconnect the power cord from the wall socket.
2. Oven beeps continuously.
3. Oven resets for operation when cool.
4. Move oven to cooler location.
5. If problem persists call service agent.
6. Oven will operate even if failure code appears, just not as designed. Call service agent.
7. Press Stop/Reset Pad and try again.
Note: Above Codes shown in the display do not indicate all the possible failures on the unit.

Installation Instructions for Stacking

Important
1. Disconnect the power cord from the wall socket
before attempting installation.
2. For stacking installation, you must use the
Panasonic Joint Plate A1134-3280 (Available via
service route).
3. Combination of the unit for stacking is limited within
only the following models.
NE-2153-2, NE-1653, NE-2143-2, NE-1843,
NE-1643
4. Do not stack more than one oven above bottom
oven.

PROBLEM
Joint Plate
Projection

Fig. 1
1./2./3./4./5.
1./5.
1./5.
5./6./7.
1./5.
Check and change the time.
— See page 15, step 3 "Note".
Preparation
Be sure the oven cavity is empty.
Installation
1. Stack the units and remove five screws a as shown
in Fig. 1.
2. Loosen the screw b.
3. The projection on the Joint Plate must face away
from the oven. Place the Joint Plate on the screw
b.
4. Attach and tighten five screws a and the screw b.
See Fig. 2.
5. Ensure the top oven is at a safe and workable
height.
Joint
Plate
Projection
- 29 -
WHAT TO DO (BELOW)
Fig. 2