Installation Instructions For Stacking; Self Diagnostics Failure Code Explanation - Panasonic NE-2156-2 Bedienungsanleitung

Installation Instructions for Stacking

IMPORTANT
1. Disconnect the power cord from the wall socket
before attempting installation.
2. For stacking installation, you must use the
PANASONIC Joint Plate which is enclosed with this
unit.
3. Combination of the unit for stacking is limited within
only the following PANASONIC models:
NE-1057, NE-1457, NE-1247, NE-1747, NE-1047,
INSTALLATION
1. Stack the units and remove five screws (a) as shown in Fig.1.
2. Loosen the screw (b).
3. Projection on Joint Plate must face away from the oven. Place Joint Plate on the screw (b).
4. Attach and tighten five screws (a) and the screw (b). See Fig.2.
5. Ensure the top oven is at a safe and workable height.
(b)
Fig. 1

Self Diagnostics Failure Code Explanation

This oven monitors its operation and displays a Failure Code in Digital Display Window when a problem occurs.
What to do when a Failure Code appears: Unplug the oven and wait more than ten seconds before
reconnecting. If normal operation does not resume, follow the next chart.
CODE PROBLEM
F01 Too high temperature of
exhausted air
F33-34 Defective thermistor circuit
F05 Defective memory IC
F81-82 Defective relay circuit
F86-87 Defective relay circuit
F44 Defective control panel
Note: Above codes shown in Digital Display Window do not indicate all possible failures on the unit.
4. The maximum stacking height is the total heights of
PREPARATION
Be sure the oven cavity is empty.
Joint Plate
Projection
(a)
The oven shuts off automatically. Disconnect the power cord from the wall socket.
The oven beeps continuously and resets for operation when cool. Move the oven
to the cooler location. If the problem persists, call service agent.
The oven shuts off automatically. If the problem persists, call service agent.
If the problem persists, call service agent. The oven will operate even if Failure
Code appears, just not as designed. If the problem occurs during memory
heating, press Stop/Reset pad. Then other memory program and manual heating
will be possible.
If the problem persists, call service agent. The oven will operate even if Failure
Code appears, just not as designed. Press Stop/Reset pad and try again.
The oven shuts off automatically. If the problem persists, call service agent.
The oven shuts off automatically. If the problem persists, call service agent.
- 13 -
NE-1447, NE-1257, NE-1757, NE-1442, NE-1856,
NE-1456, NE-1846, NE-1446, NE-2146-2,
NE-2156-2
two units.
Joint Plate
Projection
Fig. 2
WHAT TO DO