Dismantling, Returning And Disposal; Dismantling; Returning; Disposal - KIPP K1494.01 Bedienungsanleitung

1 . Di s mant ling, Re tu r ni ng an d D is posal
7 .1 Dis man tling
Before dismantling the Gateway, all linked devices must be disconnected.
INFO!
Disconnection of connected devices
Because of the secure connection, if linked KIPP devices are not disconnected, they cannot be
reconnected to another Gateway.
If the existing Gateway is no longer available due to a defect, a disconnection is effected by briefly
removing the battery of the devices.
To disconnect the linked KIPP devices, proceed as described in section 5.3.2.
Then disconnect the electrical connections as prescribed and slide the Gateway off the top-hat rail.
7 .2 R etu rn in g
When shipping the device, please note the following:
All equipment sent to HEINRICH KIPP WERK must be free of hazardous substances (acids, alkalis,
solutions, etc.) and must therefore be cleaned before returning.
It is recommended that the original packaging be used when returning the device. Alternative suitable
transport packaging may be used.
Please consult your contact person before returning the goods. The address for returning goods can be
found in the Service section.
7 .3 Dis posa l
Incorrect disposal can pose risks to the environment. Dispose of equipment components and packaging
materials in an environmentally friendly manner in accordance with the country-specific waste
treatment and disposal regulations.
Do not dispose of in household waste. Ensure separate disposal according to national
regulations.
HEINRICH KIPP WERK GmbH & Co. KG
Heubergstrasse 2
72172 Sulz am Neckar
Tel. +49 7454 793-0
Fax +49 7454 793-33
43
info@kipp.com
www.kipp.com Status: 26.11.2020