KIPP K1494.01 Bedienungsanleitung Seite 23

9 . Konf o rm itä t se rkl är un g / Com p lian ce St a te men t
Compliance statement
FCC Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)
(2)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
In order to comply with FCC Exposure requirements, this device must be installed to provide at least
20 cm separation from the human body at all times.
Compliance Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) This device may not interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
product description:
type designation / model:
product number:
Manufacturer:
HEINRICH KIPP WERK GmbH & Co. KG
Heubergstrasse 2
72172 Sulz am Neckar
this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause
undesired operation.
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.
Consult the dealer or an experienced radio/TV technician for help."

gateway
K1494.01
K1494.01
Heinrich Kipp Werk GmbH & Co. KG
Heubergstr. 2
DE-72172 Sulz am Neckar
Tel. +49 7454 793-0
Fax +49 7454 793-33
info@kipp.com
www.kipp.com
23
Stand: 26.11.2020